Radio Shack Quick Printer II Operation Guide

Transferring a Program
From a Diskette with TRSDOS 1.3,
JULY 1, 1981
To the Network 3 Software Diskette
At the Host Computer:
6. Make sure that your disk drive contains the diskette with the program(s)
you
want to ~n on the Network 3, not your Network 3 software diskette.
When the screen reads: You type:
TRSDOS Ready [ID [A] 00 IT] ~ I ENTER I
How Many Files? I ENTER I
Mem.ory Size? I ENTER I
7. (In this example, the filename ADDITION is used. Be sure to use the
actual filename of the program you want to run.)
When the screen reads:
Ready
You type:
uJ [QJ oo [ID • oo lID lID rn rn rn [Q] oo ~
!ENTER!
8. When the red light on the disk drive goes off, remove your program
diskette. Insert a backup copy of the Network 3 software diskette, with the
label facing up and the square notch to the left. Close the disk drive door.
9. When the screen reads:
Ready
You type:
Eru oo oc1 [EJ • oo lID lID rn rn rn [Q] oo ~
!ENTER!
10. If the screen displays "Disk full" , follow steps A through F below:
A.
Be sure the Network 3 software diskette is still in the disk drive.
B. Since
the last program you attempted to transfer to the diskette was
not completely copied, you must remove the partial copy of the
program from the diskette. (In this example, the filename ADDITION
is used. Be sure to use the actual filename of the last program you
attempted to transfer.)
When the screen reads: You type:
~~ oorn~uJ • OOlIDlIDrnoorn[Q]oo~
!ENTER!
21

Radio Shack Quick Printer II Specifications

General

Brand	Radio Shack
Model	Quick Printer II
Category	Desktop
Language	English