Radio Shack Quick Printer II Operation Guide

22
C. That copy of the Network 3 software diskette is full, so remove it from
the disk drive and store it away.
D.
Make another backup copy of the original Network 3 software diskette
following the directions in Appendix IV on page 33.
E. Store the original Net work 3 software diskette supplied with this
package in a safe place.
F. You
can now transfer the program to the new backup copy of the
Net work 3 software diskette. Continue from Step 6 above.
11.
If you have additional programs you want to run with the Network 3, wait
until the red light on the disk drive goes off. Then remove the Net work 3
software diskette . Place an adhesive tab over the square notch in the
diskette containing the programs you want to run with the Network 3.
Insert the diskette in the drive, with the label facing up and the covered
square notch to the left. Close the disk drive door. If you are not certain
that this diskette contains TRSDOS 1.3 July 1, 1981, follow Steps 4 and 5
above.
If the diskette does contain this version of the operating system,
continue from Step 7 above.

Radio Shack Quick Printer II Specifications

General

Brand	Radio Shack
Model	Quick Printer II
Category	Desktop
Language	English