Radio Shack Telephone Interface II System Manual

Inserting
a
Floppy
Diskette
1. Power up your Built-in Hard Disk
System and press
(RPD
(BREAK) The "INSERT
DISKETTE"
message
will
be
displayed.
2.
Make sure the
drive
latch
is in the
vertical
position.
Drive
Drive Latch
3. Carefully insert the
TRSDOS-II
operating
system
diskette
into
Drive
0,
with the label facing
the
display.
Push the diskette
into the slot
until
it locks
into
place.
NOTE:
To make
a Backup
of the
supplied
TRSDOS
2.0b and
TRSDOS-II
Diskettes
see
Chapter
6.
4.
Rotate the drive latch clockwise
until
it locks into
a
horizontal
position. After a few
seconds,
the
start-up
message,
which
is
shown below, appears on the
display.
Note:
Never
turn the
System on
or off when
a
diskette is in
a
drive.
Doing so can destroy
your
data.
78

Radio Shack Telephone Interface II Specifications

General

Brand	Radio Shack
Model	Telephone Interface II
Category	Desktop
Language	English