The process for determining other log-on sequences always follows this pattern. For
more specific instructions see "Creating an Auto Log-On Sequence" in your owner's
manual (p.
9l).
After this log-on sequence has been stored in the ADRS.DO file, you can access
TELCOM and press FIND
(CEIl) to retrieve
IS
and then call the telephone number
by
pressing CALL
(~).
After a few seconds, you'll be logged into the system and have
access
to
the News service.
This
is
an example
of
the kind of information you would get:
GOOD
NEWS
FOR
M100
OWNERS:
IT
WAS
LEARNED
THAT
SEVERAL
NEW
VENDORS
HAVE
RELEASED
SOFTWARE
PRODUCTS
FOR
THE
M100
PORTABLE
COMPUTER.
CONTACT
THEM
DIRECTLY
FOR
MORE
INFORMATION:
ABC
SOFTWARE
INC.
1234
ANYSTREET,
NEW
YORK,
NY
00100
DEF
MICROWARE
5678
SCENIC DR,
COMPUVILLE,
CA
14567
MACRoSoFT
8876
WONDER
WAY,
WETSVILLE,
WA
88734
To log-off the system, type
BYE
(ENTER)
or press
CfI).
A log-off message, such
as
THANK
YOU
FOR
USING
THE
M100
USERS
BULLETIN
BOARD
SYSTEM
DISCONNECTING
••
may be displayed. Then TELCOM will display the prompt:
Disconnect?
Enter CTI to disconnect.
If
you enter
CI),
you will keep the telephone connected
and return to the Terminal Mode.
If
you disconnect the telephone, you will return to
the TELCOM system as evidenced by the prompt:
TelcoM:
Hints and tips
...
When you first connect to a computer system, you might notice either
of
two strange
things happen
on
the display. You might, for instance, see nothing display as you type
on the keyboard. This would happen
if
you have the Model 100 set for Full Duplex
and the remote system
is
set for Half Duplex.
If
this happens, press
~
to toggle
from Full to Half Duplex.
181
To Next Page
Loading...
