Radio Shack TRS-80

12. When the screen reads:
Enter date:
Enter time:
TRSDOS Ready
Cass?
Device
= Disk to Tape -
Filespec?
Press ANY key when
Cassette ready
You type:
oo [I] m oo rn m oo [I] 1 ENTER 1
(Example for September 1, 1982)
!ENTER!
oo oo ~ ~ • rn ~ ~ [Q] GJ [Q] ~ oo rn
!ENTER!
(Be sure to type a space between the
[[] and the [I]).
For Network 1, type [JJ
For Network 2, press 1-E-N-TE_R_I
[I] [I] [ID [ID [[] [ID [I] [Z] ~ [M] [ID
!ENTER!
!ENTER!
The Student Station System Software will now load into the Student
Stations. Two asterisks will appear in the upper right corner of each
Student Station that is loading, and the right asterisk will blink.
Now, follow
Steps 13 through 16 below in exact order.
At each Student Station:
13. "*?" will appear again. Type [Z] I ENTER L
14. When "Baud rate?" appears, press I ENTER L The screen should now display
'' Network 3'' and a blinking cursor.
At the Host Computer:
15. When "TRSDOS Ready" appears, type [HJ [Q] [I] [I] I ENTER L
16. When "Baud rate?" appears, press I ENTER L
You can now load programs from the Host computer into the Student Stations,
following
Steps 16 and 17 on page 6.
16