Wrile-Protect Switch. When the switch is lighted, the
disk
drive
is write protected so that you cannot write Information on it.
Pressing
the switch turns the
write protection
on and off. Press
this switch onty when the
drive
is
not
in
use-
Otherwise,
you
may
lose
or destroy data.
Warning: Never
move
yuur
hard
disk
drive
while
the
tlr
ive is run-
ning.
Doing
so
may cause permanent damage to the drive or disk.
Also, do not
»xposR
a hard
disk
to a
strong mngnfitie
fisM, fiiinh
as Ihat produced by a
bulk eraser You could
lose valuable
data
or damage the unit. Remember, you cannot bulk erase a hard
disk.
Power-Up Procedure
1.
Be
sure
all Uoppy
diskette
drives are empty,
Turn
on all
peripheral
equipment (such
as a
printer or
external
floppy
diskette drives).
2.
Turn
on
all
hard disk
drives
by
turning
the power
key,
which
is
locked
on i
tie
primary
hard disk
drive, Clockwise.
Wan
fui
all secondary
drive
power lights to come on before continu-
ing
Then
remove
the
key
3.
Turn
on the computer.
Power-Down Procedure
1.
The operating
oyntcm prompt should
bo
the last line on your
screen. II it
is not,
press
("Entefo
or exil your
program
so that
the prompt appears.
2. Remove all
floppy
diskettes
from their drives,
a
turn
orr
any
peripheral
equipment.
4. Turn off all hard disk
drives
by
turning
the power key
counterclockwise.
5. Turn
oft
the
computer.
10
To Next Page
Loading...
