Power ON/OFF the Radio
1. Turn [VOL] switch clockwise to power on the radio, the LCD displays the Norms and then
displays channel number.
2. Turn [VOL] switch counter-clock-wise until you hear a click. The radio is powered off.
Adjusting the Volume
To turn up the volume, turn the volume clock-wise.
To turn the volume down, turn the volume counter-clock-wise. Be careful not to turn it too far,
as you may inadvertently turn your radio off.
Channel Selection
Use the channel selector keys [UP] and [DN] keys at the microphone for channel selection.
The actual channel is displayed on the LCD. For communication, the same channel and the
same modulation type AM/FM has to be selected.
1. Short press [UP] key to change CB channels. Channel will increase by 1;
Long press [UP] key for a few seconds and release, channel will increase by 1 per second.
2. Likewise, short press [DN] key to decreased by 1;
long press [DN] key for a few seconds and release, channel will decreased by 1 per second.
Chapter 2 - Know about this radio
1. A/F Key: Channel Scan
2. SQ Key: SQ_ASQ/SQ_SQ
3. LC Display
4. RFG Key: Receive RF Gain control
5. ENG Key: Emergency channel witching/Keyboard lock
6. Power/Volume Knob
7. Antenna Jack (Type SO-239) for Plug Type PL-259
8. External speaker Jack (3,5mm)
To Next Page
Loading...
Need help?
General
