Need help?Do you have a question about the Radioddity DB25-D and is the answer not in the manual?
General| Waterproof Rating | IP54 |
|---|---|
| Display | LCD |
| Bluetooth | No |
| GPS | No |
| Frequency Range | 400-470MHz |
| Power Output | 5W |
| Channel Spacing | 12.5KHz/25KHz |
| Operating Voltage | 7.4V |
Important instructions for safe and proper use of the radio.
Covers preparation and mounting procedures for the DB25-D radio.
Covers preparation and mounting procedures for the DB40-D radio.
Covers initial setup and battery charging for the GD-88 radio.
Describes the parts and functions of the radio controls for all models.
Explains how to use the radio's keys and control knobs.
Describes common, analog, and digital functions of the radio.
Instructions on how to power the radio on and off.
Guides on adjusting the radio's audio volume and squelch level.
Instructions on switching between VFO A and VFO B for operation.
How to select channels, switch between VFO/Channel modes, and set frequency.
How to use the emergency alarm function and its modes.
How to enable/disable scanning and roaming, and set pilot/burst tones.
How to set transmit power and choose the VFO for calls.
Steps for receiving and initiating digital radio calls.
How to receive and respond to analog radio calls.
Manages the radio's address book for calls and DMR functions.
Allows sending and receiving text messages (SMS) within the DMR network.
Allows selection and customization of zones and channels.
Adjusts basic radio settings like language, backlight, and keypad lock.
Configures parameters like TOT, power, squelch, and sleep mode.
Instructions for installing the necessary device driver for the programming cable.
Steps to install the Customer Programming Software (CPS).
How to launch and begin using the CPS application for radio configuration.
Procedures for saving, reading, and writing radio codeplugs.
How to perform a factory reset using the radio or CPS.
Configures fundamental radio settings like Radio ID and Name.
Allows users to define functions for programmable keys.
Adjusts microphone gain levels for better audio transmission.
Configures advanced DMR services like remote monitor and kill.
To Next Page
