Radioddity Extended manual for Radioddity DB25-D, DB40-D & GD-88 v3.0
© Radioddity 2023 page 172 of 252
12.14.3 Scan TX Mode
During scanning process, it is allowed to initiate a call or reply back on the current
channel by pressing the [PTT]-key when a scanned signal disappeared or scanning
stops.
Options: Current channel Transmit only in the initial channel before the
scan starts.
Last Operated Channel Transmit only in the last operated channel
where the radio stays lastly or scan stops.
Appointed channel Transmit only on the selected channel.
default: Appointed channel
Notes: The ‘Scan TX Mode’ is only valid when ‘Talkback’ function set ‘off’ or after
scanned signal disappears within 3s.
12.14.4 Appointed Channel
To select a specific channel out of all channels that are within your various zone
definitions for transmitting and replying during scanning. When set to ‘Off’, the
channel won't be available for transmitting and replying during scanning.
Default: Off
Notes: The setting is only used, when the ‘Scan TX Mode’ is set to ‘Appointed Channel’.
12.14.5 Optional Channel
Displays all available channel members that can be added to the scan/roaming
list.
Notes: When you add a member shown in the ‘Optional Channels’ window to the
scan/roaming list, the selected channel member information will no longer
appear in the ‘Optional Channels’ window, unless you delete the channel
member from the ‘Selected Channels’ window.
12.14.6 Selected Channels
Lists all channel members selected and added to the scan/roaming list. You can
add up to 50 channel members. You can review the available scan/roaming list
member information in the ‘Selected Channels’ window. You can also remove any
of the channel members from the ‘Selected Channels’ window, and the removed
channel members will no longer participate in any activity of the scan/roaming list
members. Any available channel can optionally be associate to the scan/roaming
list.
To Next Page
Loading...
