Radioddity Extended manual for Radioddity DB25-D, DB40-D & GD-88 v3.0
© Radioddity 2023 page 96 of 252
2. Rotate the [ENC] knob or use the [▲/▼]-keys to choose Power and press the
[Select]-key to choose between High Power and Low Power and press the
[Select]-key to confirm.
3. ‘Power is set’ pops up on the screen → return to the previous level.
10.7.3 Slot/Repeat
The Slot/Repeat setting is set according to the channel type of the currently
selected channel (Repeater with different TX/RX frequencies or TX and RX being
both the same frequency).
1. Access the menu, press the [Menu]-key and rotate the [ENC] knob or use the
[▲/▼]-keys to choose Parameters and then press the [Select]-key to enter.
2. Rotate the [ENC] knob or use the [▲/▼]-keys to choose from the following
options:
If the currently selected channel is setup with different RX/TX frequencies
(typically repeater):
(1) Slot/Repeat → press the [Select]-key to enter
• rotate the [ENC] knob or use the [▲/▼]-keys to choose between either
Slot 1 or Slot 2 → press the [Select]-key to confirm → ‘Set OK!’ pops up on
the screen → return to the previous level.
• Repeat/Off → press the [Select]-key → rotate the [ENC] knob or use the
[▲/▼]-keys to choose either Repeater mode or Talkaround → press the
[Select]-key to confirm → ‘Set OK!’ pops up on the screen → return to the
previous level.
Notes: For more details, please check chapter 6.16 Repeater / Talk Around
on page 64.
The functionality may also be accomplished by pressing the preset
[Scan On/Off]-key to turn the scan On or Off.
If the currently selected channel is setup with same RX/TX frequencies
(typically hotspot):
(1) Slot/Repeat → press the [Select]-key to enter
• Rx TimeSlot → press the [Select]-key → rotate the [ENC] knob or use the
[▲/▼]-keys to choose option of either ON, Slot 1 or Slot 2 → press the
[Select]-key to confirm → ‘Set OK!’ pops up on the screen → return to the
previous level.
• Tx TimeSlot → press the [Select]-key → rotate the [ENC] knob or use the
[▲/▼]-keys to choose option of either ON, Slot 1 or Slot 2 → press the
To Next Page
Loading...
