Radioddity Extended manual for Radioddity DB25-D, DB40-D & GD-88 v3.0
© Radioddity 2023 page 182 of 252
If this parameter is set to ‘Off’, a call on the channel will not be possible, making it
a RX-only channel. Only those Contacts, defined within the ‘Contact list’ may be
selected.
Notes: This parameter is only available in digital mode.
13.24 EAS (Emergency Alarm System)
Connect all available digital emergency systems to this channel for emergency
usage. To disable the use of the digital Alarm List, select ‘Off’.
Before using the Emergency Alarm System, it needs to be defined within the
‘Digital Alarm list’.
Notes: This parameter is only available in digital mode. Digital Alarm systems are
not supported within Ham radio networks.
13.25 Relay Monitor
Users can set the radio to output the received signal to the speaker during the
repeating operation. The option applies only for the specific channel.
Options: On Received signal will be heard if matching the specified
settings for digital RX-Group
Off No voice will be heard
Default: Off
13.26 Relay mode
The user can set the working mode of the current channel when the channel is in
relay mode.
Options: Off The channel may not be used for Relay operation.
Only RX Only receive is enabled when the channel is in relay
mode.
Only TX Only transmitting is enabled when the channel is in
relay mode.
RX and TX Receive and transmitting are enabled when the
channel is in relay mode.
Default: Off
13.26.1 Crossband analog to analog
Input channel: Set one channel for Ch Mode ‘A&D, TX-A’ and set it for Relay
mode ‘Only RX’ or ‘Rx and TX’. The frequency specified for RX
will be used for either cross repeating the analog signal
received.
Output channel: Set another channel for Ch Mode ‘Analog’
To Next Page
Loading...
