Radioddity Extended manual for Radioddity DB25-D, DB40-D & GD-88 v3.0
© Radioddity 2023 page 100 of 252
confirm → ‘Set Ok’ pops up on the screen and returns to the previous
level.
• DCS → press the [Select]-key → rotate the [ENC] knob or use the [▲/▼]-
keys to choose the DCS code → press the [Select]-key to confirm → ‘Set
Ok’ pops up on the screen and returns to the previous level.
• DCS Reverse → press the [Select]-key → rotate the [ENC] knob or use
the [▲/▼]-keys to choose the DCS Reverse code → press the [Select]-
key to confirm → ‘Set Ok’ pops up on the screen and returns to the
previous level.
10.7.10 CTCSS Phase Reverse (Ctcss Tail)
1. Access the menu, press the [Menu]-key and rotate the [ENC] knob or use the
[▲/▼]-keys to choose Parameters and then press the [Select]-key to enter.
2. Rotate the [ENC] knob or use the [▲/▼]-keys to choose CtcssTail and press
the[Select]-key to enter.
3. Choose one of the options 55Hz, 120°, 180° or 240° and press the [Select]-key
to confirm.
4. ‘Set OK!’ pops up on the screen and returns to the previous level.
10.8 Tone Set
If It is allowed by the Radioddity CPS software, set and check the prompt tones by
accessing the Tone Set menu.
10.8.1 Profiles
1. Access the menu, press the [Menu]-key and rotate the [ENC] knob or use the
[▲/▼]-keys to choose Tone Set and then press the [Select]-key to enter.
2. Rotate the [ENC] knob or use the [▲/▼]-keys to choose Profiles and press the
[Select]-key to enter.
3. Rotate the [ENC] knob or use the [▲/▼]-keys to choose General or Silent, and
press the [Select]-key to confirm the selection.
4. ‘Profile is set’ pops up on the screen and returns to the previous level.
To Next Page
Loading...
