Radioddity Extended manual for Radioddity DB25-D, DB40-D & GD-88 v3.0
© Radioddity 2023 page 95 of 252
3. Press the [OK]-key to confirm the factory reset, or press the [Back]-key to
cancel.
Notes: If you restore the factory settings, the radio will be restored with those settings
that have previously been saved using the Radioddity CPS as your radios
factory settings. All data will be overwritten by those as saved for the factory
reset procedure. You can change your preferred "factory settings" with the
Radioddity CPS at any time. Thus, this "Factory Reset" is not a real reset of the
radio. For more details, please check chapter 11.3 Factory Reset on page 122.
10.7 Parameters
If it is allowed by software, TOT, Power Setting, Repeater Setting, High / Low
Power, TimeSlot, Repeater settings, Power Saving mode, etc. can be set and/or
checked through the Parameters menu.
10.7.1 TOT
The Call Time is for limiting the time of each call, which can be used to avoid
affecting the normal communication of other users due to a long-lasting
transmission of the radio.
1. Access the menu, press the [Menu]-key and rotate the [ENC] knob or use the
[▲/▼]-keys to choose Parameters and then press the [Select]-key to enter.
2. Rotate the [ENC] knob or use the [▲/▼]-keys to choose TOT and press the
[Select]-key to enter.
3. Rotate the [ENC] knob or use the [▲/▼]-keys to choose the Call Time(s)
between Off, 20…500 sec. and press the [OK]-key to confirm.
4. ‘Calltime is set’ pops up on the screen and the radio returns to the previous
level.
TOT time: Maximum: 500s
Minimum: 20s
Increment: 10s
10.7.2 Power
1. Press the preset [High/Low Power option]-key to switch the power between
high and low.
or
1. Access the menu, press the [Menu]-key and rotate the [ENC] knob or use the
[▲/▼]-keys to choose Parameters and then press the [Select]-key to enter.
To Next Page
Loading...
