Radioddity DB25-D - TX Freq [Mhz]; Tx Qt;Dqt

Radioddity Extended manual for Radioddity DB25-D, DB40-D & GD-88 v3.0
© Radioddity 2023 page 156 of 252
12.10.8 TX Freq [MHz]
The frequency specified with this parameter for analog APRS is totally
independent of the selected channels frequency. The APRS beacon is transmitted
using 1200 Baud AFSK. The frequency data within the following table is subject to
change without prior notice.
Region
Frequency
Argentina, Uruguay
144.9300 MHz
Australia
145.1750 MHz
Austria (test)
433.8000 MHz
Brazil
145.5700 MHz
Chile
144.3900 MHz
China
144.6400 MHz
Colombia
144.3900 MHz
Europe
144.8000 MHz
Germany
432.5000 MHz
Indonesia
144.3900 MHz
Japan
144.6400 MHz
Malaysia
144.3900 MHz
Netherlands (test)
430.5125 MHz
New Zealand
144.5750 MHz
North America
144.3900 MHz
Russia
144.8000 MHz
South Africa
144.8000 MHz
Taiwan
144.6400 MHz
Thailand
145.5250 MHz
Default: 0
12.10.9 TX QT/DQT
It may be required to setup CTCSS or DCS whenever transmitting your position on
analog APRS to a repeater or iGate. This parameter is normally ‘off’ (no CTCSS/DCS
used), but may be assigned any of the supported CTCSS frequencies or DCS/DCS-
I values. See Appendix A for supported CTCSS frequencies and DCS/DCS-I values.
Default: Off