Radioddity DB25-D - Busy Channel Lockout (BCLO); Signaling

Radioddity Extended manual for Radioddity DB25-D, DB40-D & GD-88 v3.0
© Radioddity 2023 page 99 of 252
10.7.8 Busy Channel Lockout (BCLO)
1. Access the menu, press the [Menu]-key and rotate the [ENC] knob or use the
[▲/▼]-keys to choose Parameters and then press the [Select]-key to enter.
2. Rotate the [ENC] knob or use the [▲/▼]-keys to choose BCLO and press the
[Select]-key to enter.
3. Press the [Select]-key to turn the Busy Channel Lockout On or Off, or press the
[Back]-key to return to the previous level.
10.7.9 Signaling
1. Access the menu, press the [Menu]-key and rotate the [ENC] knob or use the
[▲/▼]-keys to choose Parameters and then press the [Select]-key to enter.
2. Rotate the [ENC] knob or use the [▲/▼]-keys to choose Signaling and press
the [Select]-key to enter.
3. Rotate the [ENC] knob or use the [▲/▼]-keys to select the choose from the
following options and procedures:
(1) RX Subaudio → press the [Select]-key to choose from the following options:
• Signaling off → press the [Select]-key to turn off the CTCSS/DCS code →
‘Set Ok’ pops up on the screen and returns to the previous level.
• CTCSS → press the [Select]-key → rotate the [ENC] knob or use the
[▲/▼]-keys to choose the CTCSS code → press the [Select]-key to
confirm → ‘Set Ok’ pops up on the screen and returns to the previous
level.
• DCS → press the [Select]-key → rotate the [ENC] knob or use the [▲/▼]-
keys to choose the DCS code → press the [Select]-key to confirm → ‘Set
Ok’ pops up on the screen and returns to the previous level.
• DCS Reverse → press the [Select]-key → rotate the [ENC] knob or use
the [▲/▼]-keys to choose the DCS Reverse code → press the [Select]-
key to confirm → ‘Set Ok’ pops up on the screen and returns to the
previous level.
(2) TX Subaudio → press the [Select]-key to choose from the following options:
• Signaling off → press the [Select]-key to turn off the CTCSS/DCS code
→ ‘Set Ok’ pops up on the screen and returns to the previous level.
• CTCSS → press the [Select]-key → rotate the [ENC] knob or use the
[▲/▼]-keys to choose the CTCSS code → press the [Select]-key to