Radioddity Extended manual for Radioddity DB25-D, DB40-D & GD-88 v3.0
© Radioddity 2023 page 128 of 252
12.2.8 Power Saving Ratio
Users can set the duty cycle (waketime : sleep time) of the power-saving mode.
The smaller the ratio, the lower the power consumption. A higher ratio may result
in a receiving delay or missed calls. So, it is suggested to set the duty cycle based
on its actual use. The set duty cycle is only effective when sleep mode is turned
On.
Default: 1:1
12.2.9 Save power startup time
When the radio is on standby and without any operations, it can be set a delay
time for entering sleep mode automatically.
Default: 10 s
12.2.10 Scanmode
Users can enable this function according to the working environment and actual
needs to set scan mode, so as to improve scan efficiency.
Scan mode options: CO: Carrier Off scan: Once radio receives a scanned signal
over the air, it will stay on that channel until signal
disappears, and then continue to scanning.
TO: Time-Out scan: Once the radio receives a scanned
signal over the air, it will stay on that channel for a
preset time (5/10/15/20s). Once time is over, it will
continue to scan.
SE: Seek scan: Once the radio receives a scanned signal
over the air, it will stay on that channel and stop
scanning until you re-activate to scanning.
default: CO
Notes: Whilst VFO A is selected, VFO B will no longer be monitored during scanning.
Whilst VFO B is selected, VFO A will no longer be monitored during scanning.
The non-selected VFO is used for the scanning process.
To Next Page
Loading...
