Radioddity Extended manual for Radioddity DB25-D, DB40-D & GD-88 v3.0
© Radioddity 2023 page 163 of 252
Hints: In Europe it is advised to use TimeSlot 2 for transmitting digital APRS data.
Default: Current Slot
Notes: The current firmware only allows digital APRS reporting on the same timeslot
as the current channel. We are planning to remove this limitation. Thus, for
now best leave this setting on ‘Current slot’.
12.10.26 Call Type
Depending on the digital network used by the specified APRS channel, the
transmission of the APRS beacon is either established as a ‘Private Call’ or as a
‘Group Call’. Check with your digital network provider on the required setting. As
for digital DMR Brandmeister network, APRS calls are transferred as ‘Privat Call’.
Default: Private call
12.10.27 PTT
Define if [PTT] should trigger the transmission of an APRS beacon
Options: Off Do not send an APRS beacon when radio is keyed up
On Send an APRS beacon when radio is keyed up
Default: Off
12.11 Encryption
Users are allowed to program a maximum of 10 encryption key names and their
2 Byte encryption key values. The encryption level (low, middle and high) should
be programmed to be the same. Otherwise, the encryption value can't be used. If
the encryption level is programmed to be ‘off’, this function can't be used.
Notes: This feature only works with radios of same brand and model.
This feature may not be used by HAM radio operators!
To Next Page
Loading...
