Radioddity Extended manual for Radioddity DB25-D, DB40-D & GD-88 v3.0
© Radioddity 2023 page 92 of 252
[Select]-key to confirm → ‘Level is Set’ pops up on the screen → return to the
previous level.
(3) Vox Delay → press the [Select]-key → rotate the [ENC] knob or use the
[▲/▼]-keys to choose the desired level between 1 and 4 seconds → press
the [Select]-key to confirm → ‘Vox is Set’ pops up on the screen -> return to
the previous level.
Notes: If VOX is on, when the audio amplitude reaches the preset level, the radio will
automatically initiate a call without pressing the [PTT]-key. The higher the
sensitivity level, the smaller the required audio amplitude to trigger VOX. The
lower the sensitivity level, the higher the required audio amplitude to trigger
VOX.
10.6.7 Channel Sw
If the radio is in idle state, you may the channel to be used may be selected by
means of the [ENC] knob. Therefore, the Channel Sw needs to be turned On
1. Access the menu, press the [Menu]-key and rotate the [ENC] knob or use the
[▲/▼]-keys to choose Local Set and then press the [Select]-key to enter.
2. Rotate the [ENC] knob or use the [▲/▼]-keys to choose Channel Sw and press
the [Select]-key to choose from the following options:
(1) Channel Sw → press the [Select]-key to turn it On or Off.
Notes: Whenever the channel switch is Off, rotating the [ENC] knob may not be used
to select a channel or choose a frequency.
10.6.8 ABRepeat
The Radioddity GD-88 comes with two totally independent VFOs. This allows the
radio to also operate as a repeater. Crossband-, cross mode- as well as hybrid-
and even digital-repeating are all possible. In general, there are two channel
definitions required to use the repeating functionality.
1. Press the preset [Relay On /Off]-key to turn the repeater-functionality of the
GD-88 On or Off.
or
1. Access the menu, press the [Menu]-key and rotate the [ENC] knob or use the
[▲/▼]-keys to choose Local Set and then press the [Select]-key to enter.
2. Rotate the [ENC] knob or use the [▲/▼]-keys to choose ABRepeat and press
the [Select]-key to choose from the following options:
To Next Page
Loading...
