Radioddity DB25-D - Private Call Ring Tone (Pcalltone); Group Call Ring Tone (G Call Tone); Alert Ring Tone (Alerttone)

Radioddity Extended manual for Radioddity DB25-D, DB40-D & GD-88 v3.0
© Radioddity 2023 page 102 of 252
10.8.5 Private Call Ring Tone (PCallTone)
1. Access the menu, press the [Menu]-key and rotate the [ENC] knob or use the
[▲/▼]-keys to choose Tone Set and then press the [Select]-key to enter.
2. Rotate the [ENC] knob or use the [▲/▼]-keys to choose PCallTone and press
the [Select]-key to choose from the following options and procedures:
(1) PCallSW → press the [Select]-key → rotate the [ENC] knob or use the [▲/▼]-
keys to choose from one of the options of Rx Begin Tone, Rx End Tone, Tx
Begin Tone or Tx End Tone → press the [Select]-key to tick or untick the
option → press the [Back]-key to return to the previous level.
(2) PCallTone → press the [Select]-key → rotate the [ENC] knob or use the
[▲/▼]-keys to choose the Private Call Tone ring type between Off, Ring 1,
Ring 2, Ring 3, Ring 4 and Ring 5 → press the [Select]-key to confirm →
‘Tone is set’ pops up on the screen and returns to the previous level.
10.8.6 Group Call Ring Tone (G Call Tone)
3. Access the menu, press the [Menu]-key and rotate the [ENC] knob or use the
[▲/▼]-keys to choose Tone Set , and then press the [Select]-key to enter.
4. Rotate the [ENC] knob or use the [▲/▼]-keys to choose GCallTone and press
the [Select]-key to choose from the following options and procedures:
(1) GCallSW → press the [Select]-key → rotate the [ENC] knob or use the [▲/▼]-
keys to choose from one of the options of Rx Begin Tone, Rx End Tone, Tx Begin
Tone, Tx End Tone → press the [Select]-key to tick or untick the option → press
the [Select]-key to confirm or the [Back]-key to return to the previous level.
(2) GCallTone → press the [Select]-key → rotate the [ENC] knob or use the
[▲/▼]-keys to choose the Group Call Tone ring type between Off, Ring 1,
Ring 2, Ring 3, Ring 4 and Ring 5 → press the [Select]-key to confirm →
‘Tone is set’ pops up on the screen and returns to the previous level.
10.8.7 Alert Ring Tone (AlertTone)
1. Access the menu, press the [Menu]-key and rotate the [ENC] knob or use the
[▲/▼]-keys to choose Tone Set and then press the [Select]-key to enter.
2. Rotate the [ENC] knob or use the [▲/▼]-keys to choose AlertTone and press
the [Select]-key to enter.
3. Rotate the [ENC] knob or use the [▲/▼]-keys to choose the Alert Ring Tone
between Off, Ring 1, Ring 2, Ring 3, Ring 4 and Ring 5 → press the [Select]-key
to confirm.