Radioddity Extended manual for Radioddity DB25-D, DB40-D & GD-88 v3.0
© Radioddity 2023 page 37 of 252
5.3 Radioddity GD-88 Preparation
Before using the Radioddity GD-88 for the very first time, please make sure that
the supplied antenna has been mounted to the radio and that the supplied
battery has been fully charged and mounted to the radio.
5.3.1 Mount GD-88 Antenna
1. Screw the threaded SMA-m end of the antenna into the top antenna SMA-f port
on the main body.
2. Tighten the antenna clockwise.
Notes: If transmitting without an antenna or other matched load line, it could
damage the Radioddity GD-88. The antenna must be connected to the radio
before transmitting. Do not hold the antenna with your hand, as this will
reduce the radio performance.
5.3.2 Charge Radioddity GD-88 battery pack
When the battery is used for the first time, a low battery alarm may alert. Please
turn the radio off and charge the battery firstly.
Notes: Please only use the designated battery pack and charging equipment for
charging.
Please charge as follows:
2. Plug the power supply connector into the jack on the back of the charger.
3. Plug the charger power supply into a power outlet.
4. lnstall the battery or the radio (turned off!) with the battery into the charger.
5. Observe the charger LED indicators to know the current charging status:
To Next Page
Loading...
