Radioddity DB25-D - Key Tone (Keytone); Power Tone; Message Tone (Msgtone)

Radioddity Extended manual for Radioddity DB25-D, DB40-D & GD-88 v3.0
© Radioddity 2023 page 101 of 252
10.8.2 Key Tone (KeyTone)
1. Access the menu, press the [Menu]-key and rotate the [ENC] knob or use the
[▲/▼]-keys to choose Tone Set and then press the [Select]-key to enter.
2. Rotate the [ENC] knob or use the [▲/▼]-keys to choose KeyTone and press the
[Select]-key to choose from the following options and procedures:
(1) KeyRingSW → press the [Select]-key to turn it on or off.
(2) KeyRingStat → press the [Select]-key → rotate the [ENC] knob or use the
[▲/▼]-keys to choose the Key Tone level between 01 and 13→ press the
[OK]-key to confirm → ‘Keytone is set’ pops up on the screen and returns to
the previous level.
10.8.3 Power Tone
1. Access the menu, press the [Menu]-key and rotate the [ENC] knob or use the
[▲/▼]-keys to choose Tone Set and then press the [Select]-key to enter.
2. Rotate the [ENC] knob or use the [▲/▼]-keys to choose PowerTone and press
the [Select]-key to choose from the following options and procedures:
(1) LowBatToneSW → press the [Select]-key to turn it on or off.
(2) LowBatTone → press the [Select]-key → rotate the [ENC] knob or use the
[▲/▼]-keys to choose the Low Battery Tone level between 01 and 13→
press the [OK]-key to confirm → ‘Tone is set’ pops up on the screen and
returns to the previous level.
10.8.4 Message Tone (MsgTone)
1. Access the menu, press the [Menu]-key and rotate the [ENC] knob or use the
[▲/▼]-keys to choose Tone Set and then press the [Select]-key to enter.
2. Rotate the [ENC] knob or use the [▲/▼]-keys to choose MsgTone and press the
[Select]-key.
3. Rotate the [ENC] knob or use the [▲/▼]-keys to choose the Message Tone ring
type between Off, Ring 1, Ring 2, Ring 3, Ring 4 and Ring 5 → press the [Select]-
key to confirm → ‘RingType is set’ pops up on the screen and returns to the
previous level.