23
3. Click the CONNECT
4. Choose INITAIL SETUP—Mandatory Hardware—Radio Calibration
5. Click “Calibrate Radio”
There are two tool tips after you click “OK”, one for make sure both your transmitter and
receiver are powered on and connected, and the motor of your drone does not have power and
without propellers.
And then click “OK” and move all RC sticks and switches to their extreme positions so the red bars
hit the limits.
If the red bars have not any change when you move the sticks, please check the receiver have
connect success or not, make sure the receiver (maybe R9DS) is output SBUS signal (the blue LED of
To Next Page
Loading...
