EasyManua.ls Logo

RadioMaster R84 - User Manual

RadioMaster R84
2 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
R84 Receiver User Manual
15cm
bOOT
UFL
30mm
15.5mm 13.5mm
UFL
2.4GHz
DC4.5-8.4V
V2
BIND
LED
CH3/ 4
CH1/ 2
CH3
CH1
CH2
CH4
CH4
CH2
2X
SIDE
SPECIFICATIONS
•Size: 30*15*5mm
•Weight: 3g
•Channels: 4
•Power Supply: 4.5-8.4V
•Frequency Range: 2400-2483.5GHz
•Signal Format: D8 / D16v1 / SFHSS
•Output Format: PWM
•Control Distance: 1km+
•Antenna Length: 15cm
FAIL-SAFE PROTECTION
1. Press the [BIND] button once within 10 seconds of the receiver being
powered ON, and the receiver will save all the current channel values
of the remote control as the fail-safe value.
2. 10 seconds after the receiver is powered ON, the [BIND] button
function will be disabled to prevent accidental changes to to the
fail-safe settings while preparing the model
for flight.
*Note: D8 and D16 compatible receivers MUST be frequency
fine tuned prior to flight.
Once the radio is bound to the receiver:
Go to the RF Freq. fine tune option in Model Setup.
1. Lower the value until the radio loses the connection with the receiver.
? Record the value (TUNE_MIN).
2. Raise the value so that the connection is restored, then continue to
raise it until
the radio loses the connection with the receiver again.
? Record the value (TUNE_MAX).
3. Calculate the median between the two values
?(TUNE_MIN + TUNE_MAX) / 2 = TUNE_MEDIAN
4. Set RF Freq. fine tune to the median value
?Example: Connection is lost at -73 and +35; the median is -19:
*Once the Fine Tuning value is known, it can be used for all models
that use the same protoco
l.
For more information visit: https://www.multi-module.org/using-the-module/frequency-tuning
BIND METHOD
1. Turn ON your transmitter and select the desired protocol.
2. Enter bind mode on the receiver. Press and hold the [BIND]
button while powering on the receiver.
3. When the flash pattern matches the transmitter protocol, press
BIND on the transmitter. The light will flash rapidly t
hen return
to solid.
4. After binding, cycle the power to the receiver.
*Does not support frsky transmitter, only for MPM radio.
D8
D16
S-FHSS
Receiver
will cycle
between
protocols.
BOTTOM
3
GRAMS
2.4
GHZ
TOP
Including
2 Antenna
Question and Answer IconNeed help?

Do you have a question about the RadioMaster R84 and is the answer not in the manual?

RadioMaster R84 Specifications

General IconGeneral
BrandRadioMaster
ModelR84
CategoryReceiver
LanguageEnglish

Related product manuals