To Next PageTo Next Page
Need help?Do you have a question about the RadioMaster R86C and is the answer not in the manual?
General| Brand | RadioMaster |
|---|---|
| Model | R86C |
| Category | Receiver |
| Language | English |
Press and hold the BIND button on the receiver, then connect power. The receiver LED will be solid red.
Select D8 protocol on the remote, press [BIND]. Receiver LED flashes indicating successful bind.
Exit remote's BIND mode, power cycle the receiver. Solid red LED indicates successful bind.
Within 10 seconds of power-on, press BIND to save current remote channel values as failsafe.
After 10 seconds, the BIND button is disabled to prevent accidental changes to failsafe settings.
Lower RF Freq. fine tune until signal is lost, record this negative value.
Raise RF Freq. fine tune until signal is lost again, record this positive value.
Calculate the midpoint: (Negative Value + Positive Value) / 2.
