RADLEY RW3200 - Adding Engine Oil

9
3. Clean the foam air filter with soap and water or solvent and let dry.
4. Soak the foam filter in clean engine oil.
5. Gently squeeze and then pat out all excess oil and reinstall. If excess oil
remains in the foam filter it can seep through to the paper filter and
damage it.
6. Replace either filter if it is damaged.E
Note
 Running the engine without the air filter will quickly degrade the engine
 Always inspect air filter before using the pressure washer. Check and
clean the air filter according to the maintenance schedule.
3.2 ADD ENGINE OIL
1. Ensure the pressure washer is on a level surface.
2. Unscrew one oil dipstick and clean the dipstick.
3. Check the oil level by reinserting the oil dipstick without screwing it back in.
Remove the dipstick and examine the oil level. If the level is at or below the
minimum oil level marked on the dipstick, refill to the maximum oil level
mark using a funnel.
4. Reinsert the dipstick and tighten securely.
Note
 Max. oil capacity: 600mL
 SAE 10W-30 is recommended for general use.
 Do not tilt the pressure washer when adding engine oil. This could result
in overfilling and damage to the engine.
 Using non-detergent or 2-stroke oil could shorten the engine’s working
life.
Maximum Oil Level
Minimum Oil Level
0°C
10 20 30 40 50-10-20-30
20
32°F
40 60 80 100 120
°C
°F0-20
15W-50
10W-30
Synthetic 5W-30
5W-30
Eective Viscosity Range of Engine Oils
8. 6
8. 6. 2) Ta
a ft
8. 6.2) Ta ke off the spa rk a rres te r
a fte r the eng ine cool down.
8.6.2) Ta ke off the s pa rk a rrester from the
a fter the engine cool down.