RADLEY RW3200 - Working with Detergents

23
5.3 WORKING WITH DETERGENTS
Note
 Detergents are automatically applied with the low pressure black
nozzle.
 Detergent will not be applied with the high pressure nozzles.
 DO NOT use bleach.
 Dilution ratio of this pressure washer is 1:30
1. Attach the black soap nozzle to the spray wand.
2. Prepare detergent as required by job, follow directions as supplied from
manufacturer.
3. Remove cap from detergent compartment and fill. Replace when filled.
4. Spray detergent mixture on surface with long, even and overlapping
strokes. Allow detergent to set for about 3 minutes before rinsing (do
not allow detergent to dry on surface or it may cause streaking or cause
damage to the surface).
5. Rinse surface with clean water by switching to a high pressure nozzle (0, 15,
25, or 40 degree nozzles)
6. To clean equipment after use, fill the detergent tank with clean water. Spray
clean water through the black low pressure soap nozzle until tank is empty
then shut off the engine.
8. 6
8. 6
8. 6. 3)Us
s p
re
8. 6. 4)R e
8. 6.3)U s e a brus h to r emove c a rbo
s pa rk a rres ter . I f the s pa rk a
re pla ce i t.
8. 6.4)R eins ta ll the s pa rk a rrester a
8.6.3)U s e a b rus h to r emove c a rbon d epos
s pa rk a rres ter . I f the s pa rk a rres ter i
re pla c e i t.
8.6.4)R eins ta ll t he s pa rk a rr es te r a nd m uff