RADSON PTC BLOWER 950W - User Settings Customization; Maximum Ambient Temperature During Boost; Restoring Factory Settings Procedure

13
M16MI325 A03_06/18
9- To save and move automatically to the next setting, press .
SETTING OF THE MAXIMUM AMBIENT
TEMPERATURE DURING BOOST
When the Boost is enabled in Auto, Comfort, Eco or Frost protection
mode, the blower has to heat the room until the temperature limit: the
maximum ambient temperature.
When it is reached, the blower stops automatically and restart to main
-
tain this temperature until the end of Boost period.
It is preset at 25°C, you can adjust it from 20°C to 35°C by intervals of
1°C.
To exit the user settings, press
twice.
The Boost symbol and the heating indicator appear on the display and
the maximum temperature ashes.
14- You can set the Boost maximum temperature by pressing
or
from 20°C to 35°C by intervals of 1°C.
15- To save and move automatically to the next setting, press
. To
exit the user settings, press
twice.
RESTORING FACTORY SETTINGS
In order to a coming back to factory settings, proceed in the following
order:
1- From the previous setting, press
. rest appears on the display.
2- NO appears. Press or to select YES.
yes = Factory settings reset
NO = Factory settings not reset
3- Press the key
for 5 seconds. The device returns to its initial con-
guration and goes back automatically to the home display of the user
settings.
5 sec.
Parameters Factory settings
Operating
Comfort setting temperature 19°C
Eco setting temperature 15°C
Boost duration 60 min.
Keypad lock Disabled
User settings
Backlighting L3
Frost protection temperature 7°C
Maximal Boost duration 60 min.
Maximum ambient temperature
for the automatic stop of the
Boost
25°C
The following factory values will be effective:
Press
to exit the user settings.
EN
EN