OFF Voice prompts OFF
Time scanning: When the radio detects a signal, it pauses scanning and remains for
about 5 seconds. Even if the signal is still present, the radio will continue scanning.
Carrier scanning: When it detects a signal The Radio stop scanning and remains at
the scanned frequency; it continues scan when the signal disappears.
ON Voice prompt ON, Allow audible voice confirmation of a key press
LANGUAGE
ENGLISH Voice guide in English
CHINESE Voice guide in Chinese
BCL
OFF Busy channel lockout OFF
ON Disable the PTT button on a channel that is already in use.
T-DCS
OFF
None DCS
D023N···D754I
Transmit Standard DCS. Select standard tone or input non-standard tone via keypad
VOICEPRI
Subtone encryption, if enable, others can’t hear if their frequency and
CTCSS/DCS is same as yours
Input channel name, press # to switch input methodCH-NAME
Channel Name
ROGER
OFF Disable
BEEP
Enable, Sends an end-of-transmission tone to indicate to other stations that
the transmission have ended.
TONE1200 Send the frog sound
OFF
Encryption 1
Encryption 2
Encryption 3
VOICE
SC-REV
TO
CO
Search scanning. When the walkie talkie detects a signal, it exits the scan and
remains at this frequency
SE
Allows you to assign the function you want as a shortcut to the radio PF2 keys.
This corresponds to short press
23
24
PF2
SOS/LAMP/RADIO
/TXPOWER/SCAN
/SEARCH/NOAA
SOS/LAMP/RADIO
/TXPOWER/SCAN
/SEARCH/NOAA
SOS/LAMP/RADIO
/TXPOWER/SCAN
/SEARCH/NOAA
PF2
LONG
PRESS
Allows you to assign the function you want as a shortcut to the radio PF2 keys.
This corresponds to long press
Allows you to assign the function you want as a shortcut to the radio PF3 keys.
This corresponds to short press
25 PF3
26 OFFSET 0.0000 Frequency difference between radio transmission and reception
27 SFT-D
OFF
Enable access of repeater mode, OFF: None repeater shift
In frequency mode, the TX frequency equals the RX frequency plus the frequency difference.
In frequency mode, the TX frequency equals the RX frequency minus the frequency difference.
+
-
Menu Function List Menu Function List
13 14
28
POWER
ON MSG
LOGO Power on show LOGO
VOL TAGE
Show voltage
To Next Page
Loading...