No Menu Second Menu Setting
SQL 0,···,9
Setting the squelch to off will open up the squelch entirely, Squelch is
silences the receiver when there is no signal. The lower level is easier
to interfere, and in the higher level, the sensitivity is not as good as
lower level, so It is best to set it to middle
STEP
2.50K 5.00K
6.25K 10.00K
12.50K 20.00K
25.00K 50.00K
In the frequency mode, press the up and down keys to change the
step of the frequency
Selects the amount of frequency change in VFO/frequency mode
when scan or press UP/DOWN keys
Transmit at High power
SAVE
OFF
Power save disable. Selects the ratio of sleep cycles to awake
cycles(1:1,2:1,3:1,)The higher the number the longer battery lasts.
The higher number increase the RX sleep cycle, but you may miss
the first few syllables before the RX opens
VOX
0
1
2 TXP
HIGH
Middle
Transmit at Middle power
Transmit at Low power
3
1.Normal Mode
2.Super Mode
3.Deep Mode
4
OFF
Disable Voice Transmit function
Activate the VOX function, level 1 is most sensitivity. When enable,
it is not necessary to push the PTT button.
LOW
···
1,2,···,9
5
WIDE
Wideband(25Khz bandwidth)
NARROW
Narrowband(12.5Khz bandwidth)
W/N
ON Background light is always on.
OFF
OFF
Operate beep OFF
Receive Standard CTCSS.
Select standard tone or input non-standard tone via keypad
Transmit Standard CTCSS.
Select standard tone or input non-standard tone via keypad
Receive Standard DCS. Select standard tone or input non-standard tone via keypad
OFF None CTCSS
OFF None DCS
OFF None CTCSS
ON
OFF
TDR
ON
Operate beep ON, Allows audible confirmation of a key press
Time out timer for transmit. This feature provides a safety switch that limits transmission
time to a programmed value. This will promote battery conservation by not allowing you
to make excessively long transmissions, and in the event of a stuck PTT switch it can
prevent interference to other users as well as battery depletion.
Used to create new channels(0 through 256) so that they can be accessed from
MR/Chanel mode, If the Icon“CH-”is displayed, the channel already stored
Delete a stored channel
If there is no CH in the front, the channel has no parameters and the operation is invalid
Backlight auto switch off time
Dual frequency standby OFF
Dual frequency standby ON
Menu Function Menu Function List
11 12
To Next Page
Loading...