RADTEL RT-900 - Page 9

38 RP-STE
OFF
1,2,3.4.5….10S
RPT-RL
OFF
1,2,3,4,5….10S
MDF-A
FREQ A BAND show frequency
This function is used eliminate squelch tail noise when communicating through a
repeater (1-10 sec)
Delay the tail tone of repeater(1-10s)
CH A BAND show channel number
A BAND show channel name
NAME
MDF-B
FREQ B BAND show frequency
CH B BAND show channel number
B BAND show channel nameNAME
39
40
41
B In dual standby mode, press PTT to transmit in B Band
42
OFF In dual standby mode, press PTT to transmit in Main Band
A In dual standby mode, press PTT to transmit in A BandTX-A/B
DTMF Signal codes29
S-CODE
DTMF
1,2.3...15
30
DTMF
CODE
OFF Disable
BOT Transmit DTMF code when press PTT
EOT Transmit DTMF code when release PTT
BOTH Transmit DTMF code both when press PTT and release
31 DTMFST
OFF
When transmitting (press PTT), Type DTMF code, radio will not emit the sound code
When transmitting (press PTT), Type DTMF code, radio will emit the sound codeDT-ST
ANI-ST
When transmitting (press PTT), DTMF auto sending code, radio will emit the sound code
DT+ANI
When transmitting (press PTT), DTMF auto sending code or type DTMF code via
keypad, radio will emit the sound code
32 AUTOLOCK
OFF Keypad lock turn off
5S、10S、15S Time to auto keypad lock
Add or delete the channels into scan list
To send out a burst tone, you simultaneously press PF2 key while holding
down the PTT
33
SCAN
ADD
ADD/Delete
34 TONE
1000hz,1450hz,
1750hz,2100hz
35 PTT-LT
0,100,...,
1000Ms
Delay time before automatic DTMF transmitting
37 VOX DELAY 0.5SEC...2.0SEC
36
MENU
EXIT
TIME
5,10,...,60S During the menu operation, the delay time for exiting due to no operation.
VOX delay time
Menu Function List Menu Function List
15 16