• open side doors of the weighing chamber,
• remove transport lock (1) – press the lock gently and turn it accordingly to
OPEN/CLOSE instruction, next remove the lock; please retain the lock should the
device be transported in the future,
• inside the weighing chamber place lower shield of the weighing chamber (2),
• put centering ring [framing facing downwards] (3),
• in the centre of centering ring assembly the weighing pan (4),
• put anti-draft shield in the chamber (5),
• close side doors of the weighing chamber,
• plug the balance to mains, pin of power adaptor should be connected to socket in
the back of balance housing.
Balance PS
Remove the adhesive tape. Carefully remove the balance from its packaging.
Remove all the elements necessary for correct operation from the accessory
box. Carefully remove the plastic and foil transport protective elements and
gently place the balance in its intended place of use.
Assemble the weighing pan, and other elements according to below schema:
Assembling a balance with reading interval 10mg:
- remove the adhesive tape
protecting the mass spring on one
of the rubber bumpers (1),
- assemble the weighing pan (2) on
the rubber bumpers (1),
- after assembling the balance
components, check whether the
weighing pan is firmly placed on the
rubber bumpers.
Assembling a balance with reading interval 1mg:
- remove the adhesive tape protecting the
mass spring on one of the rub
- assemble the weighing pan (2) on the
To Next Page
Loading...
