6/14
11.1. Take cord
“L2” from
stoarage board,
hang it on the
port side of the
forestay crane.
11.2. Lead the
cord through the
shrouds cross.
11.3. Clip the
clevis to the
eyelet on the port
deck.
11.4. Repeat steps 11.1-11.3
to hang the cord “R2” on the
starboard side.
12.1. Take the
cord “L3” from
the storage
board, hang it
on the base of
the port side
shrouds cross.
12.2. Clip the
clevis to the
eyelet on the
port deck.
12.4. Repeat steps 12.1-12.3
to hang the cord “R3” on the
starboard side.
13. Clip the clevis
on top of jib sail
to the forestay
crane
14. Clip the clevis
on the deck to the
front silicone ring
on jib sail.
15. Take the cord located at the rear silicone ring on the jib
boom, lead it through the eyelets on the deck as shown.
Hook the loop of the cord on the clevis at the rear of the hull
on the port side.
16. Take the cord located at the middle silicone ring on the
main boom, lead it through the eyelets on the deck as shown.
Hook the loop of the cord on the clevis at the rear of the hull
on the port side. This is the same clevis as in step 15.
To Next Page
Loading...
