RSD Rain Sensor4
For assistance, call Rain Bird Technical Services at
800-247-3782 (USA and Canada only).
6. Maintenance
The RSD Rain Sensor operates automatically and usually
requires no regular maintenance.
However, the fibrous disks inside the dial cap sometimes
become contaminated with debris or insects. If this happens,
use the following procedure to clean the Rain Sensor.
1. Turn the dial cap to the 3/4" rainfall setting, as shown in
Illustration 2.
2. Press the tab labeled Press on the side of the sensor
body, as shown in Illustration 8 (A). Then turn the dial
cap about 1¼ turns further to remove the cap from the
sensor body.
3. Remove the plunger and disks from the sensor body, and
wash them in clean water.
4. Reinstall the plunger and disks. Then reset the rainfall
setting to the desired position, as shown in
Illustration2.
Declaration of Conformity
Application of Council Directive: 89/336/EEC
Standards To Which
Conformity Is Declared:
Manufacturers Name:
Manufacturers Address:
Equipment Description:
Equipment Class:
Model Name:
EN55022 AS/NZS3548 Class A
EN50082-1:1992
EN61000-4-2
EN61000-4-3
ENV50204
EN61000-4-4
EN61000-4-6
EN61000-4-8
Clemar Manufacturing Inc.
7590 Brittania Court
San Diego, CA 92713 USA
(619) 661-4416
Irrigation Controller
Generic Res, Comm, LI - Class A
Rain Sensor
I the undersigned, hereby declare that the equipment specified above,
conforms to the above Directive(s) and Standard(s).
Place:
Tijuana, B.C., México
Signature:
Full Name:
John Rafael Zwick
Position:
General Manager
To Next Page
Loading...
Need help?
General
