Need help?Do you have a question about the Rainbow iPaul 4.300 and is the answer not in the manual?
General| Channels | 4 |
|---|---|
| Frequency response | 10Hz - 40kHz |
| Signal to noise ratio | >90 dB |
| Input sensitivity | 0.2V - 5V |
| THD | <0.05% |
| Output power @ 4 Ohms | 4 x 75W RMS |
| Output power @ 2 Ohms | 4 x 100W RMS |
| Output power bridged @ 4 Ohms | 2 x 200W RMS |
| Power Output | 4 x 75W RMS @ 4 Ohms, 4 x 100W RMS @ 2 Ohms, 2 x 200W RMS bridged @ 4 Ohms |
Crucial safety advice for vehicle work and electrical hazards during operation.
Crucial warnings about battery disconnection and installing fuses for safe power connection.
Guidance on physically installing the amplifier, emphasizing ventilation, heat, and critical safety warnings.
Details connecting power cables, fuses, and the remote turn-on signal.
Emphasizes correct polarity and phase matching to avoid sound cancellation issues.
Explains how to use bridging terminals and the required Y-RCA for mono input.
Specific use cases for bridging and critical notes on minimum impedance requirements.
Importance of cable diameter, grounding, and filtering for stable power supply.
A step-by-step guide to identifying and establishing a proper central ground connection.
Further steps for scanning, securing ground points, and mitigating distortion.
To Next Page
