Replace Y Shaft Coupler
Manual Pro2 Series - 060 Replace Y Shaft Coupler-V1.0
Tools:
① 2.5mm wrench
② 2mm wrench
③ Philips head screw driver
1. Unload filament
• In the ‘Utilities’ tab, verify that the temperature is set for your material. (215℃ for
Raise3D PLA)
• Use the arrows to adjust the temperature if required. Press the ‘unload’ button to
begin.
• The printer will begin to heat up to the designated temperature. Once the
temperature is reached the Unload button will become available.
• Press Unload to withdraw the filament.
To Next Page
