15
100M full-duplex
interface
Keep factory default setting, 100M full-duplex connection can be achieved
100M duplex
auto-negotiation
interface
Keep factory default setting, 100M full-duplex connection can be achieved
Setting rule:
Bit 6 Bit 7
OFF OFF Factory default
OFF ON 100M half-duplex
ON OFF 10M full-duplex
ON ON 10M half-duplex
Failover function
Failover function is for users with special need. In the case that all 4 E1 are inapplicable or remote Ethernet
interface status change from “Link up” to “Link down”, the local Ethernet interface will be automatically
closed down until the fault has been removed.
4.1.3 Default setting
Default setting of all bits of SW1 is OFF.
To Next Page
Loading...
