11 Raith User Guide
CHARGING THE BOARD
Your battery pack has been designed only to
operate with the included Raith Midnight charger,
it operates at a specific voltage for your Midnight
board.
BEFORE USING the board, allow the battery to
be FULLY CHARGED.
Chargers from other RAITH models or other
manufacturers must not be used to charge
this board.
Connect power to the charger by inserting the
charger plug into a power point. Now remove the
rubber grommet from the charger port on the
board and insert the charger plug.
The charger will show:
GREEN LIGHT = FULLY CHARGED
RED LIGHT = CHARGING
Once the board is fully charged (the light on the
charger will turn green) remove the charge plug
from the board, re-install the rubber grommet on
the board and remove the plug from the power
point.
WARNING: Only use the included Raith Midnight charger
with your battery pack, using any other charger is not
supported, may damage your battery and void your warranty.
To Next Page