20 Raith User Guide
HOW TO OPERATE YOUR RAITH REMOTE
Your Raith remote features a unique design for simple and
easy operation. To get started with your remote, simply
place it over your fingers similar to how a knuckle duster
would fit, and switch on the remote by holding the power
button for one second until the remote vibrates and turns
on.
Accelerating
To accelerate, slowly push the throttle thumb tab forward
and your board will start accelerating. The further forward
you push, the faster your board will go, all the way to top
speed.
Braking
In order to safely stop, please take care to slowly roll the
throttle wheel back, towards you, the further back, the
harder the braking.
When riding, if you let go of the throttle wheel, your board
will go into “free wheel” mode, and continue to coast along
using your momentum.
Please be careful when transitioning from “free wheel” to
accelerating or braking as you may need to adjust your
stance.
Turning off the remote
After riding, hold the power button for 3 seconds until the
remote vibrates to turn off, all LED lights should go off.
CHARGING THE REMOTE
It is always recommended that you charge your remote
control to 100% before each ride. This keeps remote
transmission power levels as high as possible during your
ride.
Your remote features a micro-USB type port and can be
charged from empty to full in around 1.5 hours using the
included micro-USB type cable. To charge the remote,
insert the Micro-USB plug of the charge cable carefully into
the charge port of the remote, and the USB plug end into a
suitable USB port.
To Next Page