21 Raith User Guide
The remote will show (when switched off):
NO LIGHT = FULLY CHARGED
RED LED LIGHT = CHARGING
Once the remote is fully charged remove the Micro-USB
plug from the remote.
PAIRING YOUR REMOTE
Your remote already comes paired to your board. But it is
recommended to re-pair your remote before each ride.
1. Turn on your remote by holding the power button for
one second. Hold the remote within 300mm of the rear
of the skateboard.
2. Hold the power button and the mode button for 3
seconds until the remote vibrates and the signal LED
light begins to blink red quickly. This indicates the
remote is in pairing mode.
3. Power on the skateboard and check the remote signal
light is now ON. Test the throttle and brakes for
functionality, if functions are working correctly, pairing is
successful. If the signal light is still blinking, it means
pairing has failed and the rider must restart the process
from the beginning. Switch off the remote and the
board and start again.
4. Once paired, your remote will establish a connection.
Connection Status
The remote signal light shows connection status:
Light always on indicates a good signal
Light quickly blinking quickly indicates a bad signal
Light blinking regularly indicates no signal
SWITCHING TORQUE MODE
Your remote has three torque settings. Green, Yellow and
Red. Green is low power (33% torque), Yellow is medium
power (66% torque) and Red is high power (100% torque).
Your remote control will start in green mode. The torque
mode/colour will be displayed by the remote signal LED
light.
To Next Page