22 Raith User Guide
To change torque mode, press the mode button and select
the desired torque setting.
Cruise Mode
To set cruise mode, push the thumb tab to accelerate to the
speed you require, then quickly press the power button. The
remote will vibrate once, your remote is then in cruise mode.
Press any button to exit cruise mode.
Battery Voltage Setting
Your remote is set to the voltage of your Raith Midnight,
which is 8S, so it can display the correct remaining battery
capacity. If your remote is being used with a different board
that uses a different voltage (6S-25S) but the same radio
module, the remote setting can be changed to
accommodate this so it displays the correct remaining
capacity.
To change this setting, hold the mode button for two
seconds until the receiver LED light is blinking, this means it
is in voltage setting mode. To change voltage, quickly press
the mode button to scroll through the voltage settings.
The number of LED lights illuminated will indicate the
corresponding number of battery cells (even numbers will
blink and odd numbers will be solid lights)
6S: #1 LED blinking ( <> O O O )
7S: #1 LED on ( @ O O O )
8S: #1&2 LED blinking ( <> <> O O )
9S: #1&2 LED on ( @ @ O O ) *
10S: #1&2&3 LED blinking ( <> <> <> O )
11S: #1&2&3 LED on ( @ @ @ O )
12S: #1&2&3&4 LED blinking ( <> <> <> <> )
13S: #1&2&3&4 LED on ( @ @ @ @ )
14S: #2 LED blinking ( O <> O O )
15S: #2 LED on ( O @ O O )
16S: #2&3 LED blinking ( O <> <> O )
17S: #2&3 LED on ( O @ @ O )
18S: #2&3&4 LED blinking ( O <> <> <> )
19S: #2&3&4 LED on ( O @ @ @ )
20S: #3 LED blinking ( O O <> O )
21S: #3 LED on ( O O @ O )
22S: #3&4 LED blinking ( O O <> <> )
23S: #3&4 LED on ( O O @ @ )
24S: #4 LED blinking ( O O O <> )
25S: #4 LED on ( O O O @ )
* Default for Midnight
To Next Page