NOTE:
For further information about how to access and change the programmable features of
the ParkView Rear Backup Camera, refer to “Uconnect Settings ” in “Understanding Your
Instrument Panel” in the Owner’s Manual on
www.ramtrucks.com/en/owners/manuals
for further information.
WARNING!
Drivers must be careful when backing up even when using the ParkView Rear Back
Up Camera. Always check carefully behind your vehicle, and be sure to check for
pedestrians, animals, other vehicles, obstructions, or blind spots before backing
up. You are responsible for the safety of your surroundings and must continue to
pay attention while backing up. Failure to do so can result in serious injury or
death.
CAUTION!
• To avoid vehicle damage, ParkView should only be used as a parking aid. The
ParkView camera is unable to view every obstacle or object in your drive path.
• To avoid vehicle damage, the vehicle must be driven slowly when using ParkView
to be able to stop in time when an obstacle is seen. It is recommended that the
driver look frequently over his/her shoulder when using ParkView.
NOTE:
If snow, ice, mud, or any foreign substance builds up on the camera lens, clean the
lens, rinse with water, and dry with a soft cloth. Do not cover the lens.
Turning Rear View Camera Image On:
1. Press the "Controls" button located on the bottom of the Uconnect display.
2. Press the "Backup Camera" button
to turn the Rear View Camera system
on.
NOTE:
Once initiated by the "Backup Camera" button, the Rear View Camera image may be
deactivated by pressing the "X" button on the touchscreen. On deactivation, the
previous selected screen will appear.
OPERATING YOUR VEHICLE
106
To Next Page
