To Lock The Vehicle’s Doors:
With a valid Keyless Enter-N-Go key fob within 5 ft (1.5 m) of the driver or passenger
front door handles, push door handle lock button to lock all doors.
Do NOT grab the door handle, when pushing the door handle lock button. This could
unlock the door(s).
NOTE:
• After pushing the door handle lock button, you must wait two seconds before you
can lock or unlock the doors, using either Passive Entry door handle. This is done
to allow you to check if the vehicle is locked by pulling the door handle without the
vehicle reacting and unlocking.
• The Passive Entry system will not operate if the key fob battery is dead.
The vehicle doors can also be locked by using the key fob lock button or the lock
button located on the vehicles interior door panel.
To Unlock From The Driver Or Passenger Side:
With a valid Keyless Enter-N-Go key fob
located outside the vehicle and within
5 ft (1.5 m) of the driver or passenger
side door handle, grab either front door
handle to unlock the door automatically.
For further information and applicable
warnings and cautions, please refer to your
Owner’s Manual at
www.ramtrucks.com/
en/owners/manuals.
Push The Button To Lock
Do NOT Grab The Handle When Locking
Grab The Door Handle To Unlock
GETTING STARTED
14
To Next Page
Loading...
