Lap/Shoulder Belt Operating Instructions
1. Enter the vehicle and close the door. Sit back and adjust the seat.
2. The seat belt latch plate is above the back of the front seat, and next to your arm
in the rear seat (for vehicles equipped with a rear seat). Grasp the latch plate and
pull out the seat belt. Slide the latch plate up the webbing as far as necessary to
allow the seat belt to go around your lap.
3. When the seat belt is long enough to fit, insert the latch plate into the buckle until
you hear a “click.”
Pulling Out The Latch Plate
Inserting Latch Plate Into Buckle
GETTING STARTED
22
To Next Page
Loading...
