Linking And Unlinking The Remote Keyless Entry Key Fob To Memory
Your key fobs can be programmed to recall one of two pre-programmed memory
profiles by pushing the unlock button on the key fob.
NOTE:
Before programming your key fobs to memory the feature has to be selected.
• If your vehicle is equipped with a touchscreen, you must select the “Memory To
Fob” feature through the Uconnect system. Refer to “Uconnect Settings” in
“Understanding Your Instrument Panel” in the Owner’s Manual on
www.ramtrucks.com/en/owners/manuals for further information.
•
If your vehicle is not equipped with a touchscreen, you must select the “Key Fob Linked
To Memory” feature through the instrument cluster display. Refer to “Instrument
Cluster Display” in “Understanding Your Instrument Panel” in the Owner’s Manual on
www.ramtrucks.com/en/owners/manuals for further information.
To program your key fobs, perform the following:
1. Cycle the vehicle’s ignition to the OFF position.
2. Select desired memory profile (1) or (2).
NOTE:
If a memory profile has not already been set, refer to "Programming The Memory
Feature" for instructions on how to set a memory profile.
3. Once the profile has been recalled, push and release the S (set) button on the
memory switch, then push and release button (1) or (2) accordingly. “Memory
Profile Set” (1 or 2) will display in the instrument cluster display.
4. Push and release the lock button on the key fob within 10 seconds.
NOTE:
Your key fobs can be unlinked to your memory settings by pushing the S (set) button,
and within 10 seconds, followed by pushing the unlock button on the key fob.
Memory Position Recall
NOTE:
• For vehicles equipped with an automatic transmission, the vehicle must be in
PARK to recall memory positions. If a recall is attempted when the vehicle is not
in PARK, a message will appear in the instrument cluster display.
• For vehicles equipped with a manual transmission, the vehicle speed must be at
0 mph (0 km/h) to recall memory positions. If a recall is attempted with the
vehicle speed above 0 mph (0 km/h), a message will appear in the instrument
cluster display.
Driver One Memory Position Recall
• To recall the memory settings for driver one using the memory switch, push
memory button (1) on the memory switch.
GETTING STARTED
68
To Next Page
Loading...
