GETTING TO KNOW YOUR VEHICLE 81
Cleat Removal (Standard Box Rail)
To remove the cleats from the utility rail, slide the cleat
forward to access the cut out at the end of the box rail,
then remove the cleat.
Slide Cleat Forward To Remove
Cleat Removal (With Tonneau Cover)
To remove the cleats from the utility rail, remove the end
cap screw located in the center of the end cap, using a
#T30 Torx head driver. Remove the end cap and slide the
cleat off the end of the rail.
End Cap Screw Location With Tonneau Cover
Cleat Removal (Without Tonneau Cover)
Remove the end cap by pushing upward on the release
button located beneath the end cap while pulling the cap
away from the rail. The cleat can now be removed by
sliding it off the end of the rail.
End Cap Release Button Without Tonneau Cover
Pull End Cap Away From Rail
RAMBOX — IF EQUIPPED
The RamBox system is an integrated pickup box storage
and cargo management system consisting of three
features:
Cargo storage bins
Cargo divider
Bed rail tie-down system
Ú page 80
NOTE:
Bed rail tie-down system is also available for vehicles not
equipped with a RamBox.
2
23_DT_OM_EN_USC_t.book Page 81
To Next Page
Loading...
