IN CASE OF EMERGENCY 319
There are two ways to assemble the tools:
Assembled For Spare Tire Lowering/Raising
Assembled For Spare Tire Lowering/Raising
NOTE:
If the tailgate is lowered, adding the shorter extension #5
to jack extension #4 will enable lowering the spare tire
without having to raise the tailgate.
Assembled For Jack Operation
Assembled For Jack Operation
REMOVING THE SPARE TIRE
1. Remove the spare tire before attempting to jack up
the truck. Attach the lug wrench to the extension
tubes with the curved angle facing away from the
vehicle.
2. Remove the protective cover over the access hole for
the winch mechanism by sliding the cover upward.
Access Hole Cover Location
1 — Lug Wrench
2 — Long Extension Without Spring Clip #2
3 — Long Extension With Spring Clip #3
4 — Long Extension With Spring Clip #4
5 — Short Extension #5
CAUTION!
The lug wrench can only be attached to extension #2.
When attaching the tool to the winch mechanism be
sure the large flared end opening on extension #4 is
positioned correctly over the winch mechanism
adjusting nut.
Damage to the lug wrench, extensions and winch
mechanism may occur from improper tool assembly.
1 — Lug Wrench
2 — Long Extension #2
3 — Long Extension #3
4 — Long Extension #4
5 — Short Extension #5
6 — Extension With Hook
WARNING!
After using the jack and tools, always reinstall them in
the original carrier and location. While driving you may
experience abrupt stopping, rapid acceleration or sharp
turns. A loose jack, tools, bracket or other objects in the
vehicle may move around with force, resulting in
serious injury.
7
23_DT_OM_EN_USC_t.book Page 319
To Next Page
Loading...
