84 GETTING TO KNOW YOUR VEHICLE
RamBox Emergency Release Lever
As a security measure, an Emergency Release Lever is
built into the storage bin cover latching mechanism.
In the event of an individual being locked inside the
storage bin, the storage bin cover can be opened from
inside of the bin by pulling on the glow-in-the-dark lever
attached to the storage bin cover latching mechanism.
Emergency Release Lever
BED EXTENDER — IF EQUIPPED
The bed extender has three functional positions:
Storage Position
Divider Position
Extender Position
Divider Position
The divider position is intended for managing your cargo
and assisting in keeping cargo from moving around the
bed.
There are 11 divider slots along the bed inner panels
which allow for various positions to assist in managing
your cargo.
To install the bed divider into a divider position, perform
the following:
1. Make sure the center handle is unlocked using the
vehicle key fob and rotate the center handle
vertically to release the divider side gates.
Center Handle And Lock
2. With the side gates open, position the divider so the
outboard ends align with the intended slots in the
sides of the bed.
Aligning Gate To Slots
3. Rotate the side gates closed so that the outboard
ends are secured into the intended slots of the bed.
4. Rotate the center handle horizontally to secure the
side gates in the closed position.
Side Gates Closed
5. Lock the center handle to secure the panel into place.
1 — Center Handle Lock
2 — Handle
3 — Unlocked Position
4 — Locked Position
23_DT_OM_EN_USC_t.book Page 84
To Next Page
Loading...
