RAM Promaster 2016 - To Set a Desired Speed; To Resume Speed

To Set A Desired Speed
Turn the Electronic Speed Control ON. When the vehicle has reached the desired
speed, move the electronic speed control lever upward SET(+) and release. Release
the accelerator and the vehicle will operate at the selected speed.
NOTE:
The vehicle should be traveling at a steady speed and on level ground before moving
the electronic speed control lever upward SET(+).
To Deactivate
A soft tap on the brake pedal, pushing the RES button, or normal brake pressure
while slowing the vehicle will deactivate Electronic Speed Control without erasing the
set speed memory. Rotating the center ring upward to turn the system OFF or turning
the ignition switch OFF erases the set speed memory.
To Resume Speed
To resume a previously set speed, push the RES button and release. Resume can be
used at any speed above 20 mph (32 km/h) up to the maximum speed of 100 mph
(160 km/h).
Accel/Decel
To Increase Speed
When the Electronic Speed Control is set, you can increase speed by tapping the
Speed Control lever up (+).
The drivers preferred units can be selected through the radio settings if equipped.
Refer to ”Uconnect Settings” in “Understanding Your Instrument Panel” on the DVD
for more information. The speed increment shown is dependant on the chosen speed
unit of U.S. (mph) or Metric (km/h):
U.S. Speed (mph)
• Tapping the Speed Control lever up (+) once will result in a 1 mph increase in set
speed. Each subsequent tap of the lever results in an increase of 1 mph.
• If the lever is continually held up, the set speed will continue to increase until the
lever is released, then the new set speed will be established.
Metric Speed (km/h)
• Tapping the Speed Control lever up (+) once will result in a 1 km/h increase in set
speed. Each subsequent tap of the lever results in an increase of 1 km/h.
• If the lever is continually held up, the set speed will continue to increase until the
lever is released, then the new set speed will be established.
To Decrease Speed
When the Electronic Speed Control is set, you can decrease speed by tapping the
Speed Control lever down (-).
OPERATING YOUR VEHICLE
33