RAMROD TASKMASTER 1350 PRO Series

Questions and Answers

H
herreramadisonAug 16, 2025
What to do if RAMROD TASKMASTER 1350 PRO Compact Loader engine turns over but does not start?
- L
  Lori CraigAug 16, 2025
  If the RAMROD Compact Loader engine turns over but doesn't start, several factors could be at play. First, ensure the fuel tank has clean fuel and the fuel shut-off valve is open. Then, verify that the auxiliary control lever is in neutral. If these steps don't resolve the issue, refer to the starting procedure. Additionally, a fouled spark plug could be the culprit; check the spark plug gap and clean or replace the spark plug as needed.
M
Matthew AdamsAug 19, 2025
How to fix RAMROD TASKMASTER 1350 PRO when starter does not crank engine?
- K
  Katie SmithSep 12, 2025
  If the starter on your RAMROD Compact Loader isn't cranking the engine, it's likely due to a low battery output or a loose/disconnected battery cable. Try recharging or replacing the battery. Also, check all battery cable connections and tighten them securely.
L
Louis RodriguezAug 22, 2025
Why is the hydrostatic system on my RAMROD Compact Loader so noisy?
- J
  Joy HaynesAug 22, 2025
  If the hydrostatic system in your RAMROD Compact Loader is noisy, it could be due to several reasons. There might be air in the system, which requires bleeding the system. Alternatively, check for loose suction lines and fittings, and tighten them. A clogged oil filter can also cause noise, so replace it if needed. If the hydraulic oil is too heavy, especially in cold conditions, warm it up. In case of internal pump or motor damage, consult your RAMROD dealer.
L
Loretta BeckerAug 25, 2025
What to do if RAMROD TASKMASTER 1350 PRO has erratic or no output on transmission?
- R
  Richard SanfordAug 26, 2025
  If you're experiencing erratic or no output on the transmission of your RAMROD Compact Loader, start by checking the hydraulic oil level and add oil if necessary. Ensure you are using the proper viscosity oil. Also, inspect the drive couplings between the engine and pump for any breaks, and replace them if needed.
B
Brandon ClarkAug 28, 2025
Why is my RAMROD TASKMASTER 1350 PRO overheating?
- J
  johnsonsandraAug 28, 2025
  If you're experiencing oil overheating in your RAMROD Compact Loader, first check the oil level in the reservoir and add oil if necessary. Ensure the auxiliary control lever is in the neutral position. Also, verify that the setting of the relief valve is at the correct pressure. If those steps don't help, consult your RAMROD dealer.
R
Rachel Wells PhDAug 31, 2025
What causes loss of hydraulic oil flow from gear pump in RAMROD TASKMASTER 1350 PRO Compact Loader?
- J
  James AvilaAug 31, 2025
  If you notice a loss of hydraulic oil flow from the gear pump in your RAMROD Compact Loader, begin by checking the oil level in the reservoir and add oil if necessary. Inspect the drive couplings between the engine and pump for any damage, replacing them if needed. If the issue persists, inspect and repair the hydraulic gear pump as necessary.
S
Scott TerrySep 3, 2025
What to do if hydraulic cylinders do not function properly on RAMROD TASKMASTER 1350 PRO Compact Loader?
- Q
  qkingSep 3, 2025
  If the hydraulic cylinders on your RAMROD Compact Loader aren't functioning properly, it could be due to a loss of hydraulic flow from the gear pump, so refer to troubleshooting steps for that. Another potential cause is air in the system, in which case you should bleed the system.
K
Katherine NicholsonSep 6, 2025
Why is there no drive on one side of my RAMROD TASKMASTER 1350 PRO Compact Loader?
- F
  fsmithSep 6, 2025
  If there's no drive on one side of your RAMROD Compact Loader, inspect the primary chain for failure and replace it if necessary.
D
Douglas MccannSep 9, 2025
Why is there no drive on one wheel of my RAMROD Compact Loader?
- E
  Erin JacksonSep 9, 2025
  If there's no drive on one wheel of your RAMROD Compact Loader, inspect the secondary chain for failure and replace it if necessary.
J
Janet EspinozaSep 12, 2025
How to fix noisy operation in RAMROD Compact Loader?
- T
  Theresa RobertsonSep 12, 2025
  If your RAMROD Compact Loader is operating noisily, it could be due to loose or dry chains. Try tightening the chains. If they are dry, lubricate them.

Summary

SAFETY

Safe Mini-Skid Operation

Essential guidelines and warnings for operating the mini-skid safely.

Safety Precautions and Warnings

Detailed safety rules and critical warnings to prevent accidents and injuries.

CONTROLS AND INSTRUMENTATION

Gasoline Engine Controls

Identifies and explains all controls specific to gasoline engine models.

Diesel Engine Controls

Identifies and explains all controls specific to diesel engine models.

Primary Operator Controls

Details the main levers for machine movement, lift arms, and attachment tilt.

Attachment Locking System

Explains the function and operation of the quick-attach lock pins.

OPERATION AND PROCEDURES

Pre-Operation Checks and Setup

Daily inspection and preparation steps before starting the mini-skid.

Gasoline Engine Starting Procedure

Step-by-step instructions for starting the gasoline engine.

Gasoline Engine Shutdown Procedure

Step-by-step instructions for safely shutting down the gasoline engine.

Diesel Engine Starting Procedure

Step-by-step instructions for starting the diesel engine.

Diesel Engine Shutdown Procedure

Step-by-step instructions for safely shutting down the diesel engine.

Attaching and Mounting Equipment

Guide on how to properly install and secure attachments.

Detaching and Removing Equipment

Guide on how to safely disconnect and remove attachments.

General Operating Techniques

Best practices for efficient and safe machine operation and maneuvering.

Bucket Filling and Dumping

Techniques for loading material into the bucket and emptying it.

Bucket Digging Operations

Methods and tips for effective digging with the bucket attachment.

Leveling Material with Bucket

Procedures for spreading and leveling ground surfaces.

Transporting the Mini-Skid

Instructions for safely loading, securing, and transporting the machine.

Backfilling Trenches and Holes

How to use the machine for filling operations.

Lift Arm Support Device Usage

Proper use of the support device for safety during maintenance.

Safe Lifting Procedures

Guidelines for safely lifting the mini-skid using designated lift lugs.

MAINTENANCE AND SERVICE

Gasoline Engine Maintenance

Recommended maintenance tasks for gasoline engines.

Diesel Engine Maintenance

Recommended maintenance tasks for diesel engines.

Battery Care and Servicing

Steps for inspecting, cleaning, and maintaining the battery.

Fluid, Lubricant, and Capacity Guide

Chart detailing recommended fluids, lubricants, and capacities.

Hydraulic System Maintenance

Procedures for checking oil, changing filters, and draining hydraulic oil.

Final Drive and Chain Maintenance

Instructions for adjusting and maintaining the drive chains and final drive.

Drive Chain Lubrication Schedule

Guidelines and frequency for lubricating drive chains.

Periodic Greasing Points and Procedures

Locations and methods for greasing key components like hubs and pivots.

Preventative Maintenance Schedule

A comprehensive schedule for routine maintenance tasks.

TROUBLESHOOTING

Problem Diagnosis and Solutions

Common issues, their potential causes, and recommended solutions.