Ramsa WR-DA7 - Optional Accessories

AUX SEND 1/2 :
In/Out : Out
Format : IEC 958 Consumer (S/PDIF)
Level : 0.5 V [pp]/75 Ω
Connector : RCA pin jack
WORD CLOCK IN :
In/Out : In
Level : TTL/75Ω switchable
Connector : BNC
WORD CLOCK OUT/THROUGH :
In/Out : Out
Level : TTL/75 Ω, Pass-through (75 Ω OFF) or termination (75 Ω ON)
Connector : BNC
MIDI IN :
In/Out : In
Format : MIDI
Connector : DIN Connector 5P
MIDI OUT :
In/Out : Out
Format : MIDI
Connector : DIN Connector 5P
TO PC :
In/Out : In and Out
Connector : Mini-DIN Connector 8P
RS422/485 :
In/Out : In and Out
Connector : D-sub 9P
FOOT SWITCH :
In/Out : In
Level : TTL level, Normally Open (Unlatch type)
Connector : Phone jack
Optional Accessories
Meter Bridge :
Type : Bargraph LED, 26 channels, 15 points for each
Format : RAMSA original Level NET II
Power : DC 7 V
Connector : D-sub 15P
WR-ADTA (ADAT Interface card (8 in / 8 out))
Type : ADAT (DIRECT OUT / BUS / AUX / MASTER, Input 9-32)
In/Out : In and Out
Connector : Optical
WR-TDIF (TDIF Card (8 in / 8 out))
Type : TDIF (DIRECT OUT / BUS / AUX / MASTER, Input 9-32)
In/Out : In and Out
Format : TDIF-1
Connector : D-sub 25P (in and out)
WR-AESS (AES/EBU Card (8 in / 8 out))
Type : AES/EBU/SPDIF
Signal type : RS422
Connector : D-sub 25P (in and out)